Publicidad
Wire 1/2 moon (1)
Parts Included
A. Half-moon shelf assembly
B. Side C-Hinge
C. Pin and plastic washers
D. L-bracket, screw and nut
E. Mounting screws
a
B
D
Tools Required
• Phillips head screwdriver
• Drill with 1/16" bit for pilot holes
Product
assemblies:
HM-25-G
HM-28-G
HM-34-G
KNAPE & VOGT MANUFACTURING COMPANY
2700 Oak Industrial Drive NE • Grand Rapids, MI 49505
800.253.1561 • www.kv.com
WIre HalF mooN
glide-ouT lazy susaN
Installation Instructions
Inspect all parts and read all instructions prior to beginning assembly and installation.
Step 1
Locate cabinet side for attaching half moon susan shelf.
Wrap the C-hinge around the cabinet frame so the tabs
hold the pin inside the cabinet. Screw C-hinge into place
using two long screws in the side of the cabinet face
frame, and 4 short screws into the back of the cabinet
face frame.
Step 2
The L-bracket performs as a stop for the slides. The
placement of the L-bracket on the slides is opposite the
e
cabinet door opening. Position bracket on small slide
member, align holes and fasten in place using small
round head screw and nut.
Step 3
Position plastic washers over
C
holes in the C-hinge. These will
ensure smooth operation
during shelf pivot movement.
Align the holes on the bracket
of the half moon shelf
assembly with the holes in the
C-hinge. Slide pin through all
four holes from the top
downward.
Door
Place "L"
bracket here
Top view of cabinet
RN260EFS_B_HlfMnGldeLzSusn_0213
© 2013 Knape & Vogt Manufacturing Company. All rights reserved.
Tab
Short
screws
Long
screws
step 1
step 2
Pin
Basket hinge
bracket
Washer
step 3
Publicidad
