Publicidad
Parts Included
Wire 1/2 moons (2)
A. Half-moon shelf assembly
B. Side C-Hinge
C. Pin and plastic washers
D. Door follower and screws
E. Mounting screws
A
D
B
E
Tools Required
• Phillips Screwdriver
• Drill with 1/16" bit for pilot holes
Product Assemblies
HM25
HM28
HM30
HM34
KNAPE & VOGT MANUFACTURING COMPANY
2700 Oak Industrial Drive NE • Grand Rapids, MI 49505
800.253.1561 • www.kv.com
WIRE HALF MOON PIVOT-OUT
LAZY SUSAN
Installation Instructions
Inspect all parts and read all instructions prior to beginning assembly and installation.
Step 1
Locate cabinet side for attaching half moon susan shelf.
Wrap the C-hinge around the cabinet frame so the tabs
hold the pin inside the cabinet. Screw C-hinge into place
using two long screws in the side of the cabinet face
frame, and 4 short screws into the back of the cabinet
face frame.
Step 2
Position plastic washers over holes in the C-hinge. These
will ensure smooth operation during shelf pivot
movement. Align the holes on the bracket of the half
moon shelf assembly with the holes in the C-hinge.
Slide pin through all four holes from the top downward.
Step 3
Hook the door follower up and around the top wire
C
surround of the half moon shelf, and screw to back side
of cabinet door. Caution: Make sure the mounting
screws are shorter than the thickness of the door to
prevent the screws from going through the door front.
Pin
Basket hinge
bracket
RN248EFS_B_HlfMnPvtOutLzSu_0213
© 2013 Knape & Vogt Manufacturing Company. All rights reserved.
Tab
Short
screws
Long
screws
step 1
Washer
step 2
step 3
Publicidad
