IKEA FIXA Traducido De Las Instrucciones Originales página 11

Note: The battery that is supplied with the
screwdriver/drill has been charged for test
purposes only and must be fully recharged
before first time use.
First read the safety instructions and then
follow the loading instructions. Insert
the transformer plug into the socket in
the screwdriver/drill. Then connect the
charger's transformer to the electricity
supply.
Make sure that there are no knots or sharp
bends in the cable.
The charger's transformer and the battery
have been designed to be used together.
NEVER use this charger to recharge
cordless tools or batteries from other
manufacturers. The battery will gradually
lose its charge over a period of time, even
if the tool is not used.
The lithium-ion battery is protected against
deep discharging by the "Electronic Cell
Protection (ECP)". When the battery is
empty, the machine is switched off by
means of a protective circuit: The inserted
tool no longer rotates.
WARNING!
press the On/Off switch after the ma-
chine has been automatically switched
off. The battery can be damaged.
WARNING! Recharge the battery
on a non-flammable surface.
Do not recharge the battery for more
than eight hours. The red diode will turn
green when the battery has been fully
loaded.
Do not continue to
Disconnect the cable and store the
transformer in a suitable place when it is
not in use.
It is not advisable to recharge the battery
in temperatures below freezing.
When removing the battery from the
machine, actuate the trigger switch
(5) until the battery is completely
discharged. Unscrew the screws in
the casing and take off the casing shell.
Disconnect the connections on the battery
and remove the battery (see illustration A).
INSTRUCTIONS FOR USE
Using the tool
Note: Sparks may be visible through
the slots in the motor housing during
operation. The sparks are a normal
reaction of the motor when in use and
are created by the components inside the
motor moving against each other. The
function of the power tool is not affected
by this. We do however recommend not
to use the power tool near any flammable
liquids, gases or dust, which the sparks
may ignite.
Mounting drill/driver bits
Before any work on the machine (e.g.
maintenance, tool change, etc) as well as
during transport and storage, set
direction switch to the centre position.
Unintentional actuation of the trigger can
lead to injuries. Adjust the chuck until the
opening is slightly larger than the shaft
of the drill bit that you wish to use. Insert
the drill bit into the chuck. Tighten the
chuck against the drill as described below
(Keyless chuck).
9 9
rotational