Maintenance And Cleaning - IKEA FIXA Traducido De Las Instrucciones Originales

Regulating the shaft speed
It is possible to regulate both shaft
speeds from zero to maximum by altering
the pressure applied to the trigger. This
enables you to choose the optimum speed
for the task you are working on. Use
the lower speed for tightening/loosening
screws (position 1 on the gear selector
(3)).
Selecting shaft speed
Use a low speed when starting to drill in
metal, plastic or ceramic materials, using
the screwdriver function or carrying out
work that requires a high degree of torque.
Use a high speed when drilling in wood.
(position 2 on the gear selector (3)).
Reversing the direction of rotation
You can reverse the direction of rotation by
using the rotational direction switch
To lock the trigger, set the selector to the
mid position between the right and left
options.
Adjusting the tightening moment
Turn the torque regulator (2) to the
desired position. Settings 1-19 are used for
tightening/loosening screws (the higher the
value, the greater the tightening moment).
Select the drill symbol before using the tool
for drilling.
Keyless chuck
Your drill has a keyless chuck so that you
can simply tighten or release drill/driver
bits.
To open/close the chuck hold the rear
(10) and rotate the front sleeve (11).
WARNING: RISK OF TRAPPING
Do not hold the front sleeve of the chuck
with one hand at the same time as you
open or close the jaws of the chuck with
the help of the screwdriver/drill's motor.

MAINTENANCE AND CLEANING

Before any work on the machine (e.g.
maintenance, tool change, etc) as well
as during transport and storage,
the rotational direction switch
centre position.
of the trigger can lead to injuries.
For safe and proper working, always
keep the machine and ventilation slots
clean.
ENVIRONMENTAL DISPOSAL
INSTRUCTIONS
(4).
Help to protect the environment
Information (for private households)
about the environmentally sound disposal
of electrical and electronic equipment in
accordance with the WEEE directive (Waste
Electrical and Electronic Equipment).
This symbol on electrical and electronic
products and the documentation that
accompanies them indicates that these
products may not be discarded together
with ordinary household waste. Instead the
products must be taken to a designated
collection point where they will be received
free of charge for disposal, treatment,
reuse and recycling as appropriate. In
certain countries products may also
ring
be returned to the point of sale when
purchasing an equivalent new product.
By disposing of this product in the proper
manner you are helping to save valuable
natural resources and to eliminate the
negative effects that the irresponsible
to the
Unintentional actuation
10
set