Operation - Bartscher 700298G Manual Del Usuario

Connection
DANGER! Electric shock hazard!
The device can cause injuries due to improper installation!
Before installation and connecting the local power grid
specification should be compared with that of the device (see
rating plate). Connect the device only in case of compliance!
Connect the device only to properly installed single socket
with protective terminal.

Before the first use, the mini refrigerated display should be installed and left standing
for at least 2 hours before it is connected to the power supply.

After a power failure or removal of the plug, do not reconnect the device to the
power supply for at least 5 minutes.

The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.

5.2 Operation

Preparation

Before the first use, clean the device thoroughly following the instructions in
section 6 „Cleaning".

Connect the device to a single grounded socket.

Switch the device on with ON/OFF switch (located beind the removable cover).
The device will start cooling until the set default temperature is reached.

Place the food and beverages in the refrigerated display only when the sufficient
cooling capacity has been stabilized in the device.
- 30 -