H1000REV0707:Ultrasonic Humidifier Manual 2L
READ AND SAVE THESE INSTRUCTIONS
DIRECTIONS FOR USE - OPERATING INSTRUCIONS
Make sure the unit is unplugged.
1 Separate the tank from the
body of the unit.
3 Pour cool, clean water directly
into the tank.
5 Attach the tank to the body
of the unit and plug in.
E-6
8/20/07
4:32 PM
Page 4
2 Open the tank lid, turning it
to the left.
4 Close the tank lid, turning it
to the right.
6 Press the power button to
turn on.
READ AND SAVE THESE INSTRUCTIONS
MAINTENANCE - OPERATING INSTRUCTIONS
· Always unplug the unit before servicing it in any way.
· The water temperature of the water remaining in the unit after use may be high.
· Do not submerse the unit in water, or allow water to enter the inside of the unit.
INSIDE THE BODY OF THE UNIT
Pour excess water out of the unit, but do not allow it to enter the blast port. Wash out the unit with
fresh water, using the cleaning brush and a soft cloth as needed.
OUTER SURFACE OF THE UNIT
Wipe the surface of the unit with a soft damp cloth if needed.
WATER TANK
Fill water tank with clean water and shake to remove water scaling.
ULTRASONIC DISK
Remove the water tank (Fig. 1) and use the enclosed cleaning brush regularly to remove build up
and deposits from this area (Fig. 2).
Do not use any detergents or soap as this may damage the ultrasonic disc. This may also
disperse detergent or soap residue with mist causing bodily harm.
Do not scrub with finger tips or any sharp objects as this may cause damage to ultrasonic disc.
If there is red color build on ultrasonic disc, gently clean with soft cloth with 1-2 drops of white
vinegar. Rinse with clean water.
NOTE: Ultrasonic disk expected life is about 5,000 hrs with standard use condition.
Fig. 1
STORAGE
· Fully dry the inside and outside of the unit before storing it.
· DO NOT leave water in the unit.
· Store in a cool dry place.
Fig. 2
E-7