Polytropic PAC 16 Manual De Instrucciones página 52

Water temperature setting
Press and hold 3 seconds
• "SetH" appears on the display and the setting value blinks.
• Adjust setting value with
• Press
Cooling mode
If the water temperature is higher than 30° C and yo u want to cool it; you should
set your R-PAC to stand-by mode and then to cooling mode.
To put it back on to heating mode, you have to set it to stand-by mode first and
then to heating mode.
Please read chapter "Stand-by mode" for these settings.
It is possible to install a device to automatically switch between heating and
cooling modes, available as an option.
Error messages
- Pb1 Probe 1 error (water temperature)
- Pb2 Probe 2 error (defrost temperature)
- bP
- A09 High pressure alarm
- A12 Defrost alarm
If an alarm is activated several times, the machine is stopped by security and
the alarm message will be displayed below the water temperature
To reset, it is necessary to manually stop the alarms.
Manual alarm reset
• Set the machine to stand-by mode (Please see chapter "Stand-by mode").
• Open menu setting by pressing
• Choose "ALrM" option by scrolling with
• Validate with
• Choose the corresponding alarm, it may indicate "rSt" above the alarm
code, in this case, validate with button
If it indicates "no" above the alarm code, it means that alarm cannot be reset.
In this case, please refer to "After Sales Technical Service" chapter.
• To go out of the menu, press
to confirm.
Low pressure alarm
button.
button.
and .
button.
and
to reset the alarm.
button.
- 52 -
buttons.