Publicidad
Idiomas disponibles
Idiomas disponibles
Wireless Charging Instructions
1. After the power supply is connected, the red LED light is on.
Indicating that the product entered into standby mode.
2. Put the applicable wireless charging mobile phone or QI
standard wireless receiver on the product, blue light turns on, start
charging.
3. Remove the mobile or receiver, red light turns on, return to
standby mode.
Note: The devices to be charged must be in accordance with
wireless charging function.
ATTENTION
1. Do not squeeze or impact the product.
2. Do not disassemble or transform the product.
3. Do not put the product near the fire or into the water and fire.
4. Do not use the wireless charger in severe high temperature, wet
or corrosive conditions; to avoid damage to the circuit.
5. Do not put it too close to the magnetic cards with magnetic strips
or chips (such as ID card, bankcard, and so on), to avoid magnetic
strip demagnetization.
6. Do not put metal or metal mobile phone shell on the bracket for
wireless charging.
7. Please ensure that the power supply is disconnected when you
need to clean the wireless charge HUD mobile phone navigation
support.
8. Do not use this product as a toy for children.
9. The using environment temperature is 0-45℃.
10. Keep the product screen clean, and avid scratching of the HUD
reflector.
11. For the first-time use, please download and install the latest
navigation software on the phone.
12. Please keep enough power during cell phone navigation,
please charge the phone in time when the battery is low.
Instructions
Peel the cover off the 3M glue sticky pad of the HUD navigation
support base and secure it in a suitable viewing position. Open the
HUD navigation support, set the phone to the navigation interface,
and then put the phone on the support of the anti-slip pad. Turn on
Publicidad
