Briteq BT-Profile160 LED Manual De Instrucciones página 6

ENGLISH
DESCRIPTION:
1. DISPLAY: Helps you with the configuration of the LED ENGINE. The backlight of the display starts
flashing while the projector is in DMX-mode and no DMX is detected.
2. MENU button: used to browse the setup menu, with each button press you go to the next item.
3. UP/DOWN buttons: used to change the value of the selected feature.
4. ENTER button: used to confirm the selected selection, don't forget!
5. DMX IN/OUT: both 3pin and 5pin in/outputs are available to daisy chain the projector with other units
that will be controlled by a DMX-controller.
6. MAINS FUSE: protects the unit in case of electrical problems, always use the prescribed fuse!
7. MAINS CABLE: used to connect the projector to 230V/50Hz, make sure it's always in perfect condition.
8. HANDLE: used to point the projector in the desired direction.
9. BRACKET: used to hang the projector or fix it to a floor stand, make sure the knob is well fastened.
10. SECURITY KNOBS FOR OPTICS: 2 knobs to prevent that the
OPTICS can come loose from the LED ENGINE. To change the
optics you should loosen both knobs, see further instructions in the
next chapter. To simply turn the optics over a certain angle, you only
have to loosen both knobs a little.
11. PROFILE BLADES: used to adjust the edges of the projected
beam.
12. GOBO/IRIS COMPARTMENT: this compartment can receive the
optionally available IRIS or GOBO holder. To reduce penetration of
dust, the compartment can be closed.
13. ZOOM / FOCUS KNOB: knob used to adjust the beam angle from 15° to 30° or
from 25° to 50°, depending on the optics installed. Press the lock button (**) to
unlock the mechanism and turn the knob to the left/right (*) to increase or
decrease the beam size. At the same time the focus will be automatically
adapted. Lock the knob again (**) to assure that the setting stays unchanged.
BRITEQ
®
4/35
OPERATION MANUAL
BT-PROFILE160 LED