Preparation Before Use; Cleaning & Maintenance - impress IM-701 Instructivo Antes De Usar El Producto

4
1
6
Model No. IM-702
TO USE

PREPARATION BEFORE USE

NOTE: There may be a slight smell of smoke
during first use. This is due to possible cardboard
dust on the element. The odor should stop after a
couple of minutes of use.
• Check if the electrical voltage of the main
supply and the load of the socket match the
rated voltage and power marked on the rating
label of the appliance.
• Check if the socket and the plug are undam-
aged, and put the plug well in the socket.
•
• Be sure that there is enough space for the
fan heater while operating, at least 24 inches
around the appliance, and right before the air
outlet, the distance should be at least 4 feet.
1. Turn the Thermostat Switch to the minimal
value, at the same time turn the Heat/Fan Select
Switch to the "O" position.
2. Plug in the appliance, and turn the Thermostat
Switch to the maximum position. Then turn
the Heat/Fan Select Switch to choose from Air,
Warm Air. While running, the indicator light
will be on.
2.1 Turn the Heat/Fan Select switch to "
position, and the heater will blow cool air.
2.2 Turn the Heat/Fan Select switch to "I"
position, and the heater will blow warm air,
working at 750W.
2.3 Turn the Heat/Fan Select switch to "II"
postion, and the heater will blow warm air,
working at 1500W.
4 English
2.4 Turn the Heat/Fan Select switch to "O" posi-
tion, and the heater will stop working. The
2
indicator light will switch off too.
3
3. Adjust the Thermostat Switch to a suitable posi-
tion for desired temperature setting.
3.1 Check if the Thermostat Switch is on the
maximum position.
3.2 When you feel the room temperature
5 comfortable, turn the Thermostat Switch
counter-clockwise slowly to the minimal
position until the appliance stops running.
The Thermostat Switch will keep the room at your
desired temperature automatically. You can also
turn the Thermostat Swith counter-clockwise to
the minimum position to the lower temperature.
If turned clockwise to maximum position, the
temperature will be higher.
CLEANING &
MAINTENANCE
1. Before you turn off the appliance, turn the Heat/
Fan Select Switch to the "
2 minutes to lower the internal temperature of
the heater, then turn the Heat/Fan Select switch
to "O" position to switch it "off".
2. Before you clean the appliance, turn off the
and wait until the appliance cools down
3. Clean the air inlet and outlet of the appliance
regularly (at least twice a year normally).
4. Use a dry cloth to clean the heater's surface and
dry the appliance before using or storing.
"
" position for 1 to