GYS PEARL 190.2 Manual Del Usuario página 11

SETTINgS PANEL (FIg V)
+
4
+
et
5 4
+
5 et 4
Synergic
mode
5 et 4
Advices
This mode allows quick and easy welding and has been optimised for welding angled pieces.
To obtain an identical butt weld, it is recommended to slightly reduce the setting of metal thickness.
The arc length: Lengthens (0 -> +9) or shorter (0 -> -9) to allow more or less penetration of the
metal. The display will show the changes to allow more comprehensive setting. If you are welding
for the first time, we recommend you set the arc length to 0.
+
et
5 4
PEARL 190.2
• SETUP button + Button (4) : to select
the SYNERGIC or MANUAL mode
• SETUP button + Button (5) : switching
to material settings (see table page 7)
• SETUP button + Button (4) : to select
the type of material, the recommanded
gas is then displayed
• SETUP button + Button (5) : to enter
into the settings of the Ø of the wire
• SETUP button + Button (4) : to choose
the diameter of the wire. List based on
other criteria informed
• Button (4) : to change the thickness to
be welded
• Button (5) : to change the arc length
The values U and I appear on the display
when welding
Choice of welding angle : only on SYNER-
GIC mode
• Angle button + Button (4) : to select
the torch position
• Angle button + Button (5) : to select
butt weld or fillet weld
PEARL 190.4 XL
EN
4
4
5
4
5
4
5
4
5
11