ADVERTENCIAS SAFETY INSTRUCTIONS For the safety of yourself and others around you, it is extremely important that you observe the follow- ing notes. Mixer Instructions...
Página 5
Instructions pour le mélangeur E. NETTOYAGE: Ne pas pulvériser de liquide directement sur ou dans le moteur. Il est recommandé de nettoyer soigneusement le mélangeur après chaque utilisation pour prolonger sa vie utile.
Página 6
Item # Part # Description 1000DDWB-01 Machine Bolt m12x70 1000DDWB-02 Outside Drum Plate with Straight Bushing 1000DDWB-03 Polyethylene Drum 10.0 cu. ft. 17 in. Diameter Opening 1000DDWB-04 Inside drum plate 1000DDWB-05 Bolts for drum plate 3/8” - 16 x 2 1000DDWB-06 Steel mixing blades 1000DDWB-07...
Página 8
Item # Part # Description DD-1000 Gearbox and motor assembly (110V-60Hz) DDMA-02 Screw (6x25mm) DDMA-03 Seal (40mm) DDMA-04 Screw (6x50mm) DDMA-05 Gearbox case- front half DDMA-06 Gearbox gasket DDMA-07 Pin (8x20mm) DDMA-08 Locking key for gear and axle (8x7x15mm) DDMA-09 Gearbox ball bearing DDMA-10 Gear (Z79)
Página 10
Step 2- Go to the other side and repeat the Step 3- Install spacer bar as shown Step 1- Remove all the shrink wrap from parts. same for the using the 3/8” x 2” whiz Take out all the nuts and bolts from the frame, right side but do not completely tighten lock bolts.
Página 11
Step 7- Take gear motor and remove Step 8- Tighten the 4 nuts on gear the 10 mm nuts from the 4 longer motor to 10 pounds of torque. Some- times they come loose and it is best mounting bolts in the center of the to tighten to prevent gear motor from gear motor.
Página 12
Step 18- Your mixer should now look like dones. above. If it does not, you had better call Kushlan Products’ customer service (800- Étape 17-Install poignées. Utilisez les 469-4178) broches fournis qui sont raccordés à...