Base Assembly - Lasko 3138 Instrucciones

Locate Hardware Bag "A" to Assemble Base. (Figure 1)
1. Place Base on floor.
2. Fit Mounting Flange through large hole in center of Base.
3. Insert (4) 3/8-16 X 1" Carriage Bolts through Mounting
Flange and Base.
4. Tilt Base and secure one Carriage Bolt at a time by first
putting on a 3/8" Split Lockwasher and then a 3/8-16 Hex
Nut. DO NOT FULLY TIGHTEN AT THIS TIME. Repeat above
procedure with remaining Bolts.
5. GO BACK AND FULLY TIGHTEN each Hex Nut so that the
Flange is securely assembled to the Base.
6. Thread the 3/8-16 X 1" Square Head Bolt into the Mounting
Flange.
Locate Hardware Bag "D" to Assemble Wheels to
Base. (Figures 2 and 3)
1. Remove Wheel Assemblies from Hardware Bag "D".
2. Take note that Wheel Assemblies are RIGHT and
LEFT handed. (Figure 3)
3. Place one Wheel Assembly on Base location
as shown.
4. Align two bolt holes and insert 5/16 - 18 X 1"
Long Carriage Bolt. (Figure 2)
5. Tilt Base and Secure one bolt at a time by first put-
ting on a 5/16 Split Lockwasher and then a 5/16-18
Hex Nut.
6. Repeat steps 2 thru 5 with other Wheel Assembly.
Rev. E 8/10

BASE ASSEMBLY

WHEELS TO BASE ASSEMBLY
CORRECT
Base
Split Lockwasher (4)
Figure 2
INCORRECT
Figure 3
3
Carriage Bolts (4)
Mounting Flange
Hex Nut (4)
Figure 1
Square Head
Bolt
5084445