Dura Heat WORK BOX XTR8000 Manual Del Operador página 5

OPERATION
A: Power/Fan Speed: Turn on or turn off the heater and fan
B: Heat Setting: Adjust the heat settings to function at Low, Medium or High mode, (Fan speed is not changeable).
C: LED Temperature Display: Displays set temperature and error code.
D: Temperature Setting Dial: Adjust the temperature between 59-86°F(15-30°C)
E: Overheat Indicator: Lights up if overheat auto-shutoff is activated
F: Celsius/Fahrenheit Display: Push in on the Temperature Setting Dial to change the LED Temperature Display from
Fahrenheit to Celsius.
Always operate the heater in the upright position following all instructions and recommendations listed in this manual.
Heater Location:
Place the heater in the area of the room that is the coldest.
HEATER CONNECTION
Plug heater directly into 120 volt A.C. 60 Hz outlet. Be sure the plug fits tightly in outlet. A loose connection may cause
overheating and damage to the plug or heater.
NOTE: To prevent overloading a circuit, do not plug heater into a circuit that is servicing other electrical needs.
NOTE: The heater may emit a slight harmless smoke when first used. This smoke is a normal condition caused by initial
heating of the infrared element. It will occur only briefly and is not harmful.
~ 5 ~