Quick Start - LTO TS208 Guía Del Usario

Quick Start

Items not listed under
Example 1
Example 2
Connect the left and right output of your DJ mixer, controller, etc. to Input 1 of each
loudspeaker using XLR or 1/4" (6.35 mm) TRS cables.
Tip: To send the same mix to both TS2 Series loudspeakers, connect both channels of your
DJ mixer, controller, etc. to the Input 1 and Input 2 of one loudspeaker, and then connect that
loudspeaker's Mix Out to the Input 1 of the other loudspeaker. Both TS2 Series loudspeakers
will then play identical summed mono mixes.
4
Introduction > Box Contents
Connect a dynamic microphone to the Input 1 using an
XLR or 1/4" (6.35 mm) TRS cable. Connect a guitar with
an active pickup to the Input 2 using a 1/4" (6.35 mm)
TS or TRS cable (see your guitar's documentation for
cable requirements).
Note: When using the TS2 Series loudspeaker with a
guitar, we recommend using one with active pickups
rather than passive pickups. If you use a guitar with
passive pickups, connect it to an external preamp or
direct input (DI) box, and connect the line-level output
to the loudspeaker.
Also, use dynamic microphones with the TS2 Series
loudspeaker rather than condenser microphones. If you
use a microphone that requires +48V of phantom
power, connect it to an external phantom power supply
before connecting it to the loudspeaker.
are sold separately.