Features - Kreg KMS7200 Manual De Instrucciones

9.

Features

•
The fence can be used on either side of the blade simply by switching
the fence extrusion from one side of the fence bracket to the other.
•
Position the fence extrusion anywhere along the fence bracket by
loosening the T-knobs and sliding the extrusion along the face of the
bracket. For example, to use the fence as a cutoff guide, position
the end of the extrusion slightly in front of the blade and feed the
workpiece with a miter gauge. The piece will be clear of the blade
when cut free and will not be caught between the blade and fence.
•
Switch the fence extrusion orientation from vertical to horizontal for
optimum upper blade guide support. Simply loosen the T-knobs, slide
the fence extrusion off the bolts, fl ip it over and slide the bolt heads
into the T-slot on the top of the extrusion.
With the blade close to the fence, the vertical orientation allows
lowering the upper blade guide only to the top of the fence extrusion.
The horizontal fence position allows the blade guard to be lowered
to within 1 ⁄ " of the saw table.
2
•
The clamp block features a threaded insert that accepts the optional
Micro-Adjuster accessory.