Tabla de contenido
Publicidad
8
RACK ASSEMBLY - WIND DEFLECTOR
8.4
8.5
NOTE : Once the rack is fitted to the vehicle, take it for a test drive. Should there be excessive wind noise try moving the two
Wind Deflectors slightly apart, leaving a gap of about 20 - 30mm.
RRSTUNI_REV_A04
Insert the nut assembled to the
Wind Deflector in the Combined Slat T-slot
Pocket and slide to the side as shown in
Figure 8.4.
Repeat for the other half of the
Wind Deflector.
Center the Wind Deflector on the rack and
move the bolt assemblies from Figure 8.2
into the slots as shown in Figure 8.5.
5MM
8
© 2019 FRONT RUNNER VEHICLE OUTFITTERS
Publicidad
Tabla de contenido
