ASROCK 960GM/U3S3 FX Manual Del Usuario página 23

Tabla de contenido

Publicidad

1. High Definition Audio supports Jack Sensing, but the panel wire on
the chassis must support HDA to function correctly. Please follow the
instruction in our manual and chassis manual to install your system.
2. If you use AC'97 audio panel, please install it to the front panel audio
header as below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for HD audio panel only. You don't
need to connect them for AC'97 audio panel.
E. To activate the front mic.
For Windows
Select "Mixer". Select "Recorder". Then click "FrontMic".
For Windows
Go to the "FrontMic" Tab in the Realtek Control panel. Adjust
"Recording Volume".
System Panel Header
(9-pin PANEL1)
(see p.2 No. 17)
Chassis Speaker Header
(4-pin SPEAKER 1)
(see p.2 No. 16)
Chassis and Power Fan Connectors
(4-pin CHA_FAN1)
(see p.2 No. 18)
(3-pin PWR_FAN1)
(see p.2 No. 7)
CPU Fan Connector
(4-pin CPU_FAN1)
(see p.2 No. 5)
2 2
2 2
2 2
2 2
2 2
ASRock
®
XP / XP 64-bit OS:
®
7 / 7 64-bit / Vista
TM
/ Vista
TM
This header accommodates
several system front panel
functions.
Please connect the chassis
speaker to this header.
Please connect the fan cables
to the fan connectors and
match the black wire to the
Please connect the CPU fan
1
cable to this connector and
2
3
match the black wire to the
4
ground pin.
960GM/U3S3 FX
Motherboard
64-bit OS:

Publicidad

Tabla de contenido
loading

Tabla de contenido