Vacuum Function - Hoover H-FREE 300 HYDRO Manual De Instrucciones

VACUUM AND INTEGRATED WASH FUNCTION
IMPORTANT: The integrated wash function should only be used on Hard Floors and Parquet.
This cleaner has a Hybrid Care roller at the front of the nozzle and a 360° Hydro roller at the rear of the nozzle to allow
vacuuming and wash of hard floors and parquet. [3]
1. Detach the 360° Hydro roller release flap. It is positioned on the lateral side of the nozzle. [3a]
2. Hold the 360° Hydro roller release flap and remove it. [3a]
3. Remove the sealing cap and using the sealing cap as a measuring cup fill with the provided concentrated detergent and
pour into 360° Hydro roller. [3b,3c]
4. Fill in the 360° Hydro roller with water without filling to the brim. [3d]
5. Then re-fit the sealing cap. [3e]
6. Pre wet the 360° Hydro roller with lukewarm water until the body of the Hydro roller is soft and wet. Once completed,
with your hands remove the excess water from the 360° Hydro roller. [3f,3g]
7. Re-fit the 360° Hydro roller into the nozzle to its original position and close the release flap to the nozzle. [3h]
IMPORTANT: Do not use the 360° hydro roller on carpets when it's wet.
IMPORTANT: This is a dry DC stick, do not vacuum any water or liquids.
NOTE: It is possible to use alternative gentle cleaning detergents but do not use disinfectant.
NOTE: It is recommended to wash the 360° Hydro nozzle, removing all debris with lukewarm water, before moving to
clean another floor area or room.
NOTE: When you need to refill the water tank or the 360° Hydro roller is already dirty, it is recommended to wash it in
lukewarm water with a gentle detergent by squeezing it.
IMPORTANT: It is recommended to wash the 360° Hydro roller after every use and to dry in an upright position for at
least 24 hours. [4]
IMPORTANT: Do not leave the wet 360° Hydro roller in the nozzle.

VACUUM FUNCTION

IMPORTANT: The vacuum function should only be used when the Hydro Roller is completely dry.
This cleaner has a Hybrid Care roller on the front side of the nozzle and allows pick up of dust and debris from hard floors,
parquet and carpets. [4f]
Before using your product on carpet, remove the 360° Hydro roller from the nozzle, empty the contents and leave to dry
for 24Hrs before refitting. [4]
Alternatively, if you do not want to wait, simply remove the wet 360° Hydro roller and vacuum your carpet. [4a]
USING yOUR CLEANER
USER INTERFACE
There are three working modes.
• STANDARD MODE: When you press the switch On/Off, the cleaner is ready to clean thoroughly with the main motorized
nozzle or motorized mini turbo nozzle. [7]
• TURBO MODE: Press the touch power regulation on the main body to fully power the product for hard cleaning tasks. [8]
• AUTO MODE: When the main motorized nozzle or Mini-turbo nozzle are removed, the product will automatically adapt
to the lowest power setting and turn on the Auto Led light. [9]
If more power is required for a harder cleaning task, press the touch power regulation on the main body in order to rotate
through the available power modes to suit your tasks.
BRUSH BAR STATUS
The brush bar status LED on the nozzle will stay illuminated white during all floor cleaning modes,and will turn red if the
safety protection system is activated. [21]
* Certain Models Only
4
GB