Naxa NPB-250A Manual De Operación página 6

4. When you are receiving an FM broadcast, fully extend the TELESCOPIC ANTENNA
and rotate it for the best reception.
5. Adjust the volume level to a comfortable listening level.
6. Press the STANDBY button to turn off the unit.
STORE YOUR FAVORITE RADIO STATION:
1. During listen to FM Radio, Press MODE/PROG/MEM button to store the currentstation as a
preset station. The Preset NO will flash on the LCD display.
2. Press CH-/CH+ button repeatedly to select the corresponding memory NO fromP01 - P20 to
store it
3. Press MODE/ PROG/MEM button to confirm your selection .
4. Repeat above steps to store other stations .
5. During listen to FM Radio, Repeatedly Press CH+ /CH- button to recall your preset station
STEREO PHONES JACK
A stereo phones jack has been provided on the side of the player so that you can listen without
disturbing others. To use this jack, plug in the headphones/ earphones (NOT INCLUDED) and adjust
the VOLUME control to a preferred level.
NOTE: When external headphones/earphones are connected, the speakers will be muted.
HANDLING AND MAINTENANCE OF A DISC
Follow the instructions below to handle and maintain your disc in order that
long time and trouble free performance can possibly be obtained:
Ensure not to caress the rain bow side of the disc; handle the disc by
the edge.
Long time exposure to sunshine, high temperatures and humidity will
damage the disc. And keep storage area clean.
Avoid sticking labels on both sides of a disc. Writing with pointed
articles on the disc should be strictly avoided.
Clean the disc wiping the centre and then working out to the edge with
a dry & soft cloth or a disc brush. Avoid any cleansing lotion or
chemical eradicator.
Store them in their cases when they are not to be used.
LOAD A DISC
1. Open the CD door by the Door open area.
2. Load a disc on the disc tray with the label side facing up.
3. Close the CD door.
PLAY A DISC
1. Press the STANDBY button to turn the unit on(the standby indicator will be off).
2. Press the SOURCE botton repeatedlly to switch to CD mode.
3. Follow the steps above toload a disc.
4. The player begins reading disc immediately the CD door is closed, "READING" shows in the
LCD.
5. When the disc is successfully read, TOC (total of contents) shows in the LCD and playback
follows with the first track.
6. Press Play/Pause button once to Pause music playback,the elapsed time of the current track
flashes and "PAUSE" appears on the bottom of the LCD to indicate the player in Pause mode;
Press PLAY/PAUSE button again to resume playback. press Stop button to Stop playback. The
LCD shows the TOC again.
SKIP TRACKS AND SEARCH FOR A SPECIFIC POINT TO PLAY
1. Press once the SKIP/SEARCH up button in music play to skip to the next track. To skip to a
specific track ahead, press this button several times.
2. Press once the SKIP/SEARCH down button in music play to skip to the previous track. To skip
to a specific track at back, press this button several times.
EN-5
HANDLE DISC ONLY AS SHOWN
CLEAN FROM CENTER TO EDGE
DO NOT STORE NEAR HEAT