Spypoint CELL-LINK Guia De Inicio Rapido página 8

INSTALLING AND CONNECTING THE CELL-LINK
To connect the SPYPOINT CELL-LINK to your trail camera from any
brand, follow these steps (or view our video in the Help section):
1.
Open your camera door.
2.
Take the CELL-LINK memory card
adapter cable and insert the
end with the SD card into your
camera's SD card slot.
3.
Keeping the SD memory card
adapter cable held tightly against
the case, direct the adapter cable
so that it exits from the bottom of
the camera case. The cable should
hang loosely below the camera.
(Avoid bringing the cable over any
critical components).
4.
Shut the camera door and lock the latch.
5.
Flip the SD cable upward, sliding it up behind the camera, so
that the CELL-LINK connector sticks out from behind the top
of your camera.
6.
Mount your camera to the tree. (The CELL-LINK SD adapter
cable should now be found between the tree and camera)
7.
Mount the CELL-LINK cellular module as close to your camera as possible.*
8.
Connect the SD card cable connector to the CELL-LINK.
You can now access CELL-LINK photos, configurations, and statuses
either via the SPYPOINT app or the SPYPOINT website.
It is strongly recommended to mount your CELL-LINK cellular
module directly above your camera leaving as little space as
possible between the two. Doing so will reduce the risk of
:
NOTE
having animals cause damage to the cable.
If your cable memory card adapter gets damaged,
replacement cables can be ordered separately.
8