Olimpia splendid MIA 9 Instrucciones Para La Instalación página 12

Carefully read the precautions and follow the procedures correctly.
WARNING!
In case of breakage or poor functioning always contact the Authorized Assistance Cen-
tre; any attempt to remove parts or perform maintenance on the device can expose
the user to electrical shock danger.
The stove contains parts whose maintenance must be done by qualified personnel.
stance Centre.
The stove is a heating device; its parts reach extreme temperatures and contact wi-
thout adequate protection can provoke burns of various degrees.
Pay particular attention to children.
Inside the device there is a high speed fan that could cause grave personal injury.
Pay particular attention to children.
longed exposition to the cold air could be hazardous to health.
Pay particular attention in rooms where there are children, the elderly or the ill. In case
the stove functions poorly, shut down the device immediately, unhook the appropriate
automatic switch and contact the Authorized Assistance Centre.
If you do not use the auxiliary air outlet (only for models with canalisation), check that
the fan speed is set on zero (deactivated).
Norms and conformity declarations
Legislation
• Our company declares that the stove conforms to the following norms for EC European
Directive marking.
• 2004/108 EC (EMC directive) and successive amendments.
• 2006/95 EC (low voltage directive) and successive amendments.
• 2011/65/EU
chnician installing the hydrothermal sanitary system will issue the declaration of con-
formity according to L. 37/2008. The installation of appliance has to be in accordance
with local and national laws and with European norms.
• EN 55014-1; EN 55014-2; EN 61000-3-2; EN 61000-3-3; EN 60335-1;
EN 60335-2-102; EN 62233; EN 14785; EN 50581
Responsibility
The manufacturer declines every direct or indirect, civil or penal responsibility due to:
• Poor maintenance.
• Failure to observe the instructions contained in the manuals.
• Use in non-conformity with the safety directives.
• Installation in non-conformity with the norms in force in the country.
• Use of non-original replacement parts.
• Exceptional events.
• Use of unsuitable pellets.
Installation
Flue
of an air cavity or opportune insulation.
• The internal section must be uniform, preferably circular: the square or rectangular
sections must have rounded corners with a radius of no less than 20 mm, a maximum
relationship between the sides of 1.5; the walls as smooth as possible with no narro-
wed sections, regular curves and no discontinuities, with deviations from the axis not
more than 45°.
smoke clearing tube and a height not less than that declared.
• Never use two stoves, a chimney and a stove, a stove and a wood kitchen, etc in the
same environment, since the draught of one could damage the draught of the other.
• Collective type ventilation ducts that can lower the atmospheric pressure in the in-
Installation manual
During the stove installation operation, keep children out of the work area to avoid
unforeseen accidents.
Do not block or cover in any way the body of the stove or obstruct the slits placed on
the upperside.
Do not use the stove in areas containing precision devices or works of art.
The quality of the conserved objects may deteriorate.
on plants and animals.
Occasionally ventilate the room during the use of the device.
Do not expose the stove to contact with water.
The electrical insulation could be damaged, with the consequent possibilities of elec-
trocution and breakage due to the thermal extremes.
Verify the installation conditions to locate eventual damage.
After the stove has completed 900 hours of operation (the lower screen will read
"SErV"), contact the Authorized Assistance Centre for cleaning and ordinary mainte-
nance.
Unhook the automatic switch if the device will not be used for long periods of time.
We check the start up of all our stoves.
stallation environment are not permitted, even if installed in environments that are ad-
jacent to and communicating with the locale of the installation.
from that for which it is originally intended.
• It is forbidden to pass other air feeding channels or tubes for electrical system usage
NO
12 1 1
WARNING!
NO
YES
GB