Supplies Required - Bradley S19-430EH Manual De Instalación

Installation
Installation for Eyewash Units
NOTICE! Avoid cleaners containing organic solvents, alcohols, and hydrocarbons.
Rinse with water after cleaning.

Supplies Required:

• Pipe sealant
• Hardware to mount wall bracket to wall
Close the water supply before connecting the hose assembly.
Apply pipe sealant (supplied by installer) to all male threaded pipe joints.
Use a strap wrench around the yellow pipes to prevent marring.
Step 1: Mount the hose and wall bracket
1. Connect the pipe nipple and the pipe tee to the eyewash valve.
2. Mount the wall bracket to the wall with hardware supplied by the installer. Mount in a location unobstructed to the user.
Step 2: Connect the water supply
1. Connect the ½" NPT water supply piping to the pipe tee.
2. Open the water supply line. Test for leaks and adequate water flow.
Standard eyewash unit is shown. Other units are similar.
Bradley • 215-868 Rev. L; ECN 12-05-003C
½" NPT
Supply Inlet
Pipe
Nipple
Eyewash
Valve
Spray
Hose
Wall
Bracket
Tee
10/22/2012
S19-430EH
3