Basic Configuration - Gigaset T640 PRO Instalación

Basic configuration

The PBX is now ready for operation and needs to be adjusted to the local network infrastructure
of the company. For the settings, use the Web interface of the PBX. When you first log on to the
user interface, a Setup wizard will start automatically. This guides you step by step through the
main settings.
Default settings:
Administrator ID
Administrator PIN
IP address
Network mask
Standard gateway
DHCP server
DHCP address range
The configuration is done via a Web browser on the computer you have connected to
the PBX.
The network configuration of the computer must be set to obtain the Internet
address automatically.
Starting the Setup assistant
¤
Start your Web browser
. . . the login window opens
¤
Log on as adminstrator: Enter the login name (admin) and PIN (0000).
Pay attention to upper/lower case . . . The Web user interface of the PBX opens
¤
Set the language for the assistant.
¤
The next page is for importing a backup.
¤
Choose your country
ISDN and FXS/FXO parameters
¤
Change the PIN for the administrator ID admin
You can now close the Setup wizard and enter the other settings later via the Administration
menu of the user interface.
However, it is recommended that you complete the whole wizard if you want to inte-
grate the PBX into the local network and successfully set up an outside line.
Enter further settings in the assistant:
Now close the assistant with:
You can now log on under the admin user ID with the newly assigned PIN and perform the con-
figuration.
admin
0000
192.168.0.50
255.255.255.0
none
activated
192.168.0.100 - 192.168.0.150
Enter the IP address of the PBX in the address field: 192.168.0.50
Next
Skip this page with Next
Next . . . the country-specific settings are loaded, e.g. dialling tones,
Finish installation and reboot . . . the PBX is rebooted.
Next
Next
Initial setup
3