Craftsman 200.57933 Manual Del Propietário página 24

Door Status vs. Activation
Door at fully open / close position
Door is closing
Door is opening
Door is stopped as intended in partially open position
Door is obstructed while closing
Door is obstructed while opening
Door is fully opened and photo eye system is obstructed
Courtesy Light Responses
Operation / Condition
Opener is initially plugged-in / Power restored
Upon opener activation
"LEARN" button is pressed
Remote / Keyless entry PIN code accepted
The photo eye system is obstructed during door-closing or
door is obstructed during opening
Opener motor overheat (Thermal Protection)
Manual Operation
To prevent SERIOUS INJURY or DEATH:
- Use emergency release to disconnect trolley ONLY when the door is CLOSED to prevent unexpected rapid falling in
case of a unbalanced / poor-conditioned door.
- Use emergency release ONLY when doorway is clear of persons and obstructions.
- DO NOT use emergency release to pull the door open or closed.
DISCONNECT
24
Door status
Lever
CONNECT
Flip to reconnect
Pull to Disconnect
Door will move to fully close / open position
Door will reverse
Door will stop
Close
Door will reverse while flashing courtesy light
Door will stop
Door will not close
Flashes five times
Turns on for 4-1/2 minutes and turns off automatically
Turns on for 30 seconds
Flashes twice
Flashes for 30 seconds (Re-align and clear obstruction)
Flashes 5 times (Wait about 15 minutes to cool down)
WARNING
!
In case of a power failure or door obstruction, PULL
EMERGENCY handle to release door from opener.
To Disconnect Trolley for Manual Operation
With the door closed, pull down the emergency release handle
to the DISCONNECT position. The door can be raised / lowered
manually.
To Re-connect Trolley
Pull the handle toward the opener so that the lever will flip up to
the CONNECT position. The trolley will reconnect itself when
the opener is activated or when the door is manually opened/
closed
Activation using Push Button / Remote
Courtesy Light Response