Replacing I/O Terminal Cover - peerless-AV Neptune Shade Serie Guia Del Usuario

Replacing I/O Terminal Cover

1. Run cables through bottom of I/O terminal cavity across foam gasket. All cables must exit toward
bottom of display to retain seal when I/O terminal cover is installed. Do not run cabling through
the top or sides of I/O terminal cavity. Leave approximately 1/2" (13mm) between cables to
retain seal when I/O Terminal Cover is installed.
2. Replace I/O terminal cover onto I/O terminal guides, keeping cables between the bottom
gaskets.
3. Replace and-tighten (8) screws until I/O terminal cover gasket is fully compressed to back of
display.
Failure to follow these instructions can result in the product being damaged, destroyed, and
voiding the warranty.
guides
• Ensure cord bend radius does not exceed limits set by
the manufacturer.
• Ensure cords are seated properly in the cable channels
to avoid potential damage to cords when I/O terminal
cover is installed.
• Do not run cables through the top or sides of I/O terminal
cavity. All cables must exit toward bottom of display to
retain seal when I/O terminal cover is installed.
CAUTION
guides
CAUTION
Do not overtighten screws
10
2020-11-24
Replace
#:180-9152-3 (2020-01-20)