Remote Control Battery Installation And Replacement - peerless-AV Neptune Shade Serie Guia Del Usuario

Remote Control Battery Installation and Replacement

The remote control is powered by two 1.5V AAA batteries installed at the factory.
If the Red LED light on the remote fails to illuminate when a button is pressed, the batteries may need
to be replaced. Follow the directions below to replace the batteries.
1. To remove the battery module of the remote
control, remove the two screws on the end
of the battery module. Slide the battery
module out of the remote control.
2. Insert two new "AAA" size batteries into
the battery module. Ensure the positive
and negative marks on the batteries are
correctly oriented with the markings on
the inside of the remote control's battery
compartment.
3. Slide the battery module back into the
remote control, and reinsert the two screws
in the end of the battery module to maintain
a waterproof seal (do not over tighten).
B
TV/SPK TV/SPK TV/SPK
POWER POWER POWER
TV SPK AUX1 TV AUX2 SPK AUX1 TV AUX2 SPK AUX1 AUX2
1 2 3 1 2 1 3 2 3
4 5 6 4 5 4 6 5 6
7 8 9 7 8 9 7 8 9
• 0 • 0 • 0
LAST LAST LAST
OK OK OK
MUTE MENU MUTE MUTE MENU MENU
INPUT INPUT INPUT
VOL CH VOL VOL CH CH
INFO INFO INFO
EXIT EXIT EXIT
GUIDE GUIDE GUIDE
TV/SPK TV/SPK
POWER POWER
TV SPK AUX1 AUX2 TV SPK AUX1 TV
1 2 3 1 2
4 5 6 4 5
7 8 9 7 8
• 0 • 0
LAST LAST
OK OK
MUTE MENU MUTE MUTE MENU
INPUT INPUT
VOL VOL CH VOL
INFO INFO
EXIT EXIT
GUIDE
Incorrect usage of batteries can result in leaks
or bursting. Peerless-AV recommends the
following battery use:
• Do not mix battery brands.
• Do not combine new and old batteries. This
can shorten the battery life or cause battery
acid leaks.
• Remove dead batteries immediately to
prevent battery acid from leaking into the
battery compartment.
• Do not touch exposed battery acid as it
may injure skin.
• Remove the batteries if you do not intend
to use the remote control for a long period
of time.
• Do not expose the batteries to excessive
heat from sunlight, fire or other heat
sources or batteries could explode.
• Fully tighten screws to maintain the ingress
protection rating of the remote.
14
2020-11-24
TV/SPK
POWER
AUX2 SPK AUX1 AUX2
1 3 2 3
4 6 5 6
7 9 8 9
• 0
LAST
OK
MENU
INPUT
CH CH
INFO
EXIT
GUIDE GUIDE
CAUTION
#:180-9152-3 (2020-01-20)