Tabla De Contenido; Safety Precautions; Pre-Assembly - Kreg KMA4100 Manual De Instrucciones

Table of Contents
Safety Precautions
Pre-Assembly
Recommended Tools (Not Included). . . . . . . 3
Hardware Included. . . . . . . . . . . . . . . . 3
Product Description . . . . . . . . . . . . . . . 3
Assembly

Safety Precautions

WARNING Before using a power tool with this product, read, and follow the tool manufacturer's instructions
and safety precautions in addition to the safety precautions below to reduce risk of serious injury from hazards
such as fire, electric shock, or rotating saw blade.
■ Follow your saw manufacturer's instructions and safety precautions.
■ Always wear personal protective equipment required by the saw manufacturer.
■ Do not allow familiarity gained from frequent use of your tools to replace safe work practices. A moment of
carelessness is sufficient to cause serious injury.
■ Avoid awkward hand positions where a sudden slip could cause contact with the rotating blade.
■ This product is only intended for use with circular saws. Not intended for use with other power tools such as
routers or jig saws.
■ Always secure the cutting station to prevent movement while cutting.
■ Do not attempt bevel cuts with this product.
■ Inspect your workpiece before cutting. If the workpiece is bowed or warped, ensure there is no gap between
the workpiece and fence along the cut line.
■ Always secure the workpiece with a firm grip ensuring your hand stays
outside of the cutting area as designated by the symbol.
WARNING Do not operate this tool or any machinery while under the influence of drugs, alcohol, or
medications.
WARNING This product can expose you to chemicals including Acrylonitrile, which is known to the State of
California to cause cancer. For more information go to www.P65Warnings.ca.gov.
WARNING Drilling, sawing, sanding or machining wood products can expose you to wood dust, a substance
known to the State of California to cause cancer. Avoid inhaling wood dust or use a dust mask or other
safeguards for personal protection. For more information go to www.P65Warnings.ca.gov/wood.

Pre-Assembly

WARNING Avoid cutting irregular-shaped workpieces that can twist, rock, or slip while being cut.
Review this section before you begin. Ensure you have all tools/materials that were in the package on hand and
compare them with the items listed in the Hardware Included and Product Description sections. If any item is
missing, do not use this product. Contact customer service or return product to place of purchase.
2
2 Operation
Make your Kerf Line Cut . . . . . . . . . . . . . 6
2
Make a 90° Cut . . . . . . . . . . . . . . . . . 7
Cut Different Angles . . . . . . . . . . . . . . . 8
Cut Long Workpieces . . . . . . . . . . . . . . 8
Care and Cleaning
4
Troubleshooting
6
9
9