Cut Different Angles
ATTENTION
The width of the board you will be able
to cut will vary depending on your saw and where you
position the fence.
ATTENTION
If you are not cutting the angle on
the end of the board, cut to length at 90° before
cutting the angle.
a. Position the front of the adjustable fence (G)
to the desired angle line on the material
support wings (D) on either side of the
cutting station and tighten in place.
WARNING
Position the end of the workpiece
away from the Sure-Cut™ back board to
avoid binding of the blade and kickback.
b. Tighten the fence in place and then
follow the steps and precautions in
Make a 90° Cut for making the cut.
Cut Long Workpieces
WARNING
Support long workpieces to prevent them
from sagging or shifting during the cut.
Extend the material support wings (D) for proper
support for the cut. If cutting longer boards, you can
easily remove the detachable block (1) and place near
the end of the board for outfeed and infeed support.
To remove the detachable block, lift the block straight
up from the support wing.
8
1
G
D
1
D
I
G
D