Safety; Features - Tripp-Lite isobar Manual Del Propietário

Ocultar thumbs Ver también para isobar:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

safety

iMPOrtant saFety instrUCtiOns.
saVe tHese instrUCtiOns.
This manual contains instructions and warnings that should be followed during the installation and operation of all
Tripp Lite Power Centers. Failure to heed these warnings will void your warranty.
• The Power Center features an internal protection that will disconnect the surge-protective component at the end of its
useful life but will maintain power to the load—now unprotected.
• Do not connect the Power Center to an ungrounded outlet. Do not use with 2-wire extension cords or adapters. Do not
plug extension cords into the Power Center.
• The Power Center is designed for indoor use only. Install the Power Center away from heat-emitting appliances such as
radiators or heat registers. Do not install where excessive moisture is present.
• Never install electrical wiring during a lightning storm.
• Do not drill into any part of the housing or open the housing for any reason. There are no user-serviceable parts inside.
• Use of this equipment in life support applications where failure of this equipment can reasonably be expected to cause
the failure of the life support equipment or to significantly affect its safety or effectiveness is not recommended. Do not
use this equipment in the presence of a flammable anesthetic mixture with air, oxygen or nitrous oxide.

Features

a
C
Circuit Breaker, Cord and Back Panels
Circuit Breaker & Cord Panel
a
Detachable Power Cord with Right-Angle Plug: connects the Power Center to a standard 3-wire grounded 120V AC
60Hz wall outlet. Detachable cord simplifies installation; right-angle plug permits equipment and furniture to be placed
flush against a wall.
B
Circuit Breaker: protects against dangerous system overload. If the total load on the Power Center's outlets exceeds
12 amps, the circuit breaker will trip and power will be turned off at the outlets. Reduce the load by unplugging some
devices. Depress the circuit breaker to restore power.
C
Mounting Flange: allows for secure mounting (with user-supplied screws) on any suitable surface, including on a wall
behind a flat panel TV screen. The user must determine the fitness of the mounting surface and the user-supplied screws
prior to installation.
Outlet Panel
D
"HDTV" Outlet: protects any flat panel TV (plasma, LCD or HDTV) against surge damage and line noise distortion on
the AC line. Turn power on and off at this outlet with the Power Switch.
e
"ACCESSORY" Outlet: protects any accessory (receiver, player, etc.) against surge damage and line noise distortion on
the AC line. Turn power on and off at this outlet with the Power Switch.
"LINE OK" LED: indicates that nominal AC power is present with no wiring faults detected. When this LED is
F
illuminated, AC power is safe for connected equipment.
200902150 93-2886.indd 2
J
i
B
D
Outlet Panel
2
H
g
F
e
4/6/2009 4:57:07 PM

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido