Important Safety Instructions; Quick Installation - Tripp-Lite Isobar6UltraHG Manual De Operación

Important Safety Instructions

• Use of this equipment in life support applications where failure of this equipment can
reasonably be expected to cause the failure of the life support equipment or to significantly
affect its safety or effectiveness is not recommended. Do not use this equipment in the
presence of a flammable anesthetic mixture with air, oxygen or nitrous oxide.
• This Tripp Lite Surge Suppressor is not intended for use in patient-contact applications.
• Install your surge suppressor indoors, away from excess moisture, heat and dust.
• Connect your surge suppressor to a three-wire, grounded AC power outlet. Do not remove
or modify the ground pin of the surge suppressor's plug. Do not use two-prong adapters
with the surge suppressor's plug.
• Your surge suppressor does not require maintenance. Do not open your surge suppressor
for any reason. There are no user-serviceable parts inside.
These devices feature an internal protection that will disconnect the surge
protective component at the end of its useful life but will maintain power to

Quick Installation

1 Plug surge suppressor into a
three-wire, grounded 120V
electrical outlet.
The surge suppressor cannot provide full
protection unless it is plugged into a properly
wired and grounded outlet. The
ISOBAR6ULTRAHG features a hospital-
grade plug and outlets. Grounding continuity
should be checked periodically. Grounding
reliability can only be achieved when the
ISOBAR6ULTRAHG is connected to an
equivalent grounded receptacle marked
"Hospital-Only" or "Hospital-Grade."
Flip surge suppressor's
2
ON/OFF switch ON
(switch will light up).
When this switch is lit, it indicates that AC
power is enabled at the surge suppressor's
outlets.
Note: The ISOBAR6ULTRAHG comes with a locking
switch cover to prevent accidental shut-off. Simply depress
the cover until you hear it click for locking, and lift again
to unlock.
200906154 93-2911.indd 2
the load—now unprotected.
2
1
2
7/8/2009 3:00:16 PM