Replacing Filters - Black+Decker BDH1220AV Manual De Instrucciones

Removing Dust Bowl and Filters
NOTICE:
Maximum dust collection will only be
obtained with a clean filter and an empty dust
bowl.
NOTICE:
Empty dust bowl before it becomes
overfilled. If dust begins to fall back out of the
product after it is switched off, it is too full and
requires emptying.
• Press the bowl release button (2) and pull the
dust bowl (3) away from the body of the auto vac.
• While holding the dust bowl over a bin, pull the filter
out to empty the contents of the bowl.
NOTICE:
The auto vac has a pre-filter and an
inner filter. The filters should be separated to allow
better cleaning.
• To separate the filters, twist the pre-filter (10) in
a clockwise direction and lift away from the inner
filter (11) as shown in Figure E.
• Shake or lightly brush any loose dust off both
filters.
• To replace the filters, slide the pre-filter over the
inner filter.
• Align the wings of the pre-filter with the slots in
the inner filter and twist in a counterclockwise
direction as shown in Figure F.
• Place filters back into the bowl pressing firmly to
ensure a secure fit. Place the dust bowl back onto
the auto vac until it "clicks" firmly into position.
WARNING:
correctly in position before use.
Cleaning the Dust Bowls and Filters
NOTICE:
Wash the filters regularly. The cleaner the filter is, the better the product will
perform.
• Remove the dust bowl and filter as described in "Removing Dust Bowl and Filters."
• The dust bowl and filters can be washed in warm soapy water.
• Allow to dry before placing back into the auto vac.
• Once clean and dry, place filters back into the bowl pressing firmly to ensure a
secure fit. Place the dust bowl back onto the auto vac until it "clicks" firmly into
position.

Replacing Filters

The filters should be replaced every 6 to 9 months depending on frequency of use, or
when they are worn or damaged. Replacement filters (Catalog Number: VF110) are
available from your BLACK+DECKER dealer.
Visit www.blackanddecker.com to locate dealers.
• Remove the old filters as described above.
• Fit the new filters as described above.
It is very important that the filter is
D
E
11
F
5
10