Assembling; Using The Illuminator - VWR RL20 Manual De Instrucciones

Assembling

Installing the illuminator
Screw the fixing ring on the
bottom of the Stereo head.
Place the illumanator on the
fixing ring, using the three
locking screws.
Connect the power supply
to to wall socket.

Using the illuminator

Avoid disassembling the
instrument
Do not disassemble the in-
strument. This entails the
cancellation of the warranty
and may cause malfunction.
•
Use ON/OFF switch
to turn the LEDs on.
•
Use the knob
②
adjust the light intensity.
•
Use the 4 sector but-
tons to control the
③
illumination modes:
- Full circle illumination
- Half circle illumination
- Quarter circle illumination
The power supply should be used only on network sockets equip-
ped with adequate grounding.
①
to
①
③
Always disconnect the power supply from the illuminator when
not in use for long time, while you clean it or when you perform
any maintenance.
5
Fig.1
Fig.2
②
Fig.3