Faucet Installation - Stern QUADRAT Serie Manual De Instalación Y Mantenimiento

FAUCET INSTALLATION

STEP 1 – INSTALLING THE FAUCET
Shut off the water supply.
1
Drill a hole (26 to 27 mm) where you
want to install the spout of the faucet,
2
and a small hole just above the
previous one for the anti-rotation pin.
Remove the gasket, the disk, the nut
and the flexible pipe from the base
of the faucet and insert the faucet
3
through the wall.
Note: To remove flexible pipe rotate
counter clockwize.
Secure the rosette into position using
4
the anti rotation pin.
Fix the base behind the wall with the
hexagonal nut and the disk.
Reinstall the flexible pipe into the
5
base. Rotate the pipe clockwize.
6
FAUCET INSTALLATION
QUADRAT B / E
26-27 mm
STEP 2 - CONNECTING THE WATER SUPPLY
Fit the flexible pipe coming from the
product base to the solenoid valve
housing. Fit the water supply inlet
to the adapter at the solenoid valve
1
housing.
Inlet and outlet should follow the
indicating arrow on the solenoid
housing.
NOTE: Make sure the filter is located between the solenoid housing and the water
inlet.
Connect the cable coming from the
2
electronic unit to the solenoid valve.
IMPORTANT: This product includes a self adjusting sensor.
The ideal sensor range for the specific location will be set automatically.
OBJECT
Before proceeding, check that no
objects are in front of the sensor
besides the washbasin.
QUADRAT B / E
FROM THE ELECTRONIC UNIT
TO THE SOLENOID VALVE
Now, remove the protective sticker
that covers the sensor.
7