Stern QUADRAT Serie Manual De Instalación Y Mantenimiento página 6

FAUCET INSTALLATION
STEP 3 – CONNECTING THE POWER SOURCE
For QUADRAT B: Connect the other cable com-
ing from the electronic unit at the QUADRAT
1a
base to the battery box.
For QUADRAT E: Connect the other cable
coming from the electronic unit at the
1b
QUADRAT base to the transformer. Plug the
transformer into the electricity socket.
After you have connected the power source
(battery or transformer) wait 15 seconds in
order to allow the system to set the ideal
sensor range. As an indication that the self
adjusting is taking place, a LED in the sensor
2
eye will flash continuously.
The solenoid valve will be opened and closed
for 1 second as an indication that the ideal
sensor range is set and the product is ready
for use.
Turn on the central water supply. Check for
3
leaks.
NOTE: QUADRAT includes a special aerator that
allows you to adjust the water stream direction on
site in order to prevent water splashing if needed. To
change the angle of the water stream, simply move
the adjustable tilting plate by pressing it smoothly.
ATTENTION! the aerator is tightened to prevent
removal by hand.
If the automatically adjusted sensor range is not satisfactory to your purposes,
please refer to the section entitled "Settings adjustment".
8
QUADRAT B / E
FROM THE ELECTRONIC UNIT
TO THE POWER SUPPLY
ABOUT
15
SECONDS
FAUCET INSTALLATION
STEP 1 – INSTALLING THE FAUCET
Shut off the water supply.
1
Cut an adequate opening in the wall
according to the dimensions of the
mounting box, the cables sleeve,
2
the rigid pipe (not supplied) and the
QUADRAT base with the support.
Dismantle the faucet base.
3
Drill two small holes for the product
4
base support and drive the anchors in.
QUADRAT 2030 B / 2030 E
9