Dust Cup Cleaning - Kenmore 116.31040 Manual De Uso Y Cuidado

f
DUST CUP CLEANING
1
TO DISASSEMBLE DUST CUP
Remove dust cup from vacuum cleaner
(See DUST CUP EMPTYING) and empty
contents.
1. Rotate upper dust
cup to unlock, then
lift off.
2. Remove pre-filter by
pulling downward as shown.
See PRE-FILTER CLEANING
3. Press the lid
release button
downward and
twist lid to remove
from dust cup.
4. Rotate fastener ring
to unlock, and lift off.
5. Remove upper
portion of dust cup
from air guide.
6. Rinse with cold
water only, DO NOT
use detergent or soap.
Allow parts to dry 24
hours before putting
back into vacuum
c lea ner.
DO NOT wash in the
dishwasher.
DO NOT install parts
damp.
TO ASSEMBLE DUST CUP
1. Reinstall upper
portion of dust cup
onto air guide so
that the locking
screws pass
through the
holes in the
upper portion.
2. Using alignment marks
on the fastener ring and
dust cup, place fastener
ring onto dust cup and
rotate to lock in place.
3. Place the dust cup
lid on the upper
portion of the dust cup
using aligniment slots,
and rotate until the lid
locks in place.
4. Reinstall pre-filter
by using the
alignment ribs on the
pre-filter to align with
the ribs on the upper
portion of the dust
cup.
5. Press into place. A
noticeable "click"
should be heard.
6. Reinstall lower F_
portion of the dust cup
by aligning ribs on the
upper portion with the
UNLOCK ribs on the r_
lower portion.
L2
7. Rotate until ribs
from the upper portion of the dust cup
align with the LOCK ribs.
NOTE: If lower portion of dust cup does
not fit properly check pre-filter
installation in step 4.
18