Whalen WSLWFP48-5 Manual Del Usuario página 4

ASSEMBLY INSTRUCTIONS
1a. Unpack the unit and confirm that you have all the hardware and
required parts. Assemble the unit on a carpeted floor or the empty
carton to avoid any scratch.
1b. Glue two wood dowels (CC) into the inner holes of top stretcher (L)
and attach it to the top panel (A) with three screws (FF).
Hardware Used
CC
Wood Dowel
FF
M4 x 25 mm Screw
RR
Glue
2. Securely screw 24 cam bolts (BB) into the designated small holes on
the top panel (A), bottom panel (B), lower side panels (H and I), upper
side moldings (E) and upper partition panel molding (G). Fully tighten
with a Phillips screwdriver.
Hardware Used
BB
Cam Bolt
3. Securely screw 11 cam bolts (BB) into the designated small holes on
the center shelf (C). Fully tighten with a Phillips screwdriver.
Hardware Used
BB Cam Bolt
1
FF
FF
x 2
CC
A
x 3
FF
x 1
2
A
x 24
E
B
H
3
x 11
C
6
ASSEMBLY INSTRUCTIONS
4. Glue two wood dowels (CC) into the inner holes of middle crossbar
FF
(M). Align and attach the middle crossbar (M) to the center shelf
(C) by engaging three cam locks (AA).
Hardware Used
L
AA
Cam Lock
CC
CC Wood Dowel
Glue
RR
5. Glue four wood dowels (CC) into the inner holes of the bottom front
molding (N) and bottom back strether (O) and attach them to the bottom
panel (B) by engaging six cam locks (AA).
BB
Hardware Used
G
AA
Cam Lock
I
CC
Wood Dowel
RR
Glue
6a. Glue six wood dowels (CC) into the inner holes of the previous
assembly at both ends.
6b. Align the large holes on both lower side panels (H and I) with the
inserted wood dowels and press them together. Attach the lower
side panels (H and I) in place by engaging six cam locks (AA).
Hardware Used
BB
AA
Cam Lock
CC
Wood Dowel
RR
Glue
4
Cam locks
face inward
M
x 3
C
x 2
CC
x 1
5
CC
N
x 6
B
x 4
AA
x 1
Cam locks
face inward
6
I
B
x 6
H
x 6
x 1
7
AA
O
FRONT
Finished
edge
CC
AA