Ingersoll Rand 380SQ1 Manual De Operación Y Mantenimiento página 26

14. Grasp the flats of the Housing in vise jaws with the
output spindle downward. Remove the Rear Liner
Cover Assembly and put grease in the central opening
of the Cover. Refer to Dwg. TPD1313.
15. Reinstall the Cover Assembly and use a hex wrench to
push it below the threads at the rear of the Housing.
Refer to Dwg. TPD1314.
PUSH DOWN
MAINTENANCE SECTION
GREASE
(Dwg. TPD1313)
(Dwg. TPD1314)
26
16. Install the Housing Cap (35) and using the spanner plug
furnished in the Tool Kit, tighten the Cap between 58
and 65 ft–lb (78 and 88 Nm) torque. Refer to
Dwg. TPD1315.
SPANNER PLUG
17. Make certain the Drive Shaft rotates freely and then fill
the mechanism with fluid and reassemble the tool as
instructed in the section, CHANGING THE
MECHANISM FLUID.
CLOCKWISE TO TIGHTEN
(Dwg. TPD1315)