pony CLASSIC 110 Instalación Funcionamiento Y Mantenimiento página 26

E N G L I S H
BREAKDOWNS TO THE STEAM IRON (IF FITTED)
1. Steam iron does not heat.
2. Steam iron overheating.
3. From the iron comes water
mixed with steam.
4. Steam overheated from the
iron.
BREAKDOWNS TO THE STEAM/AIR SPOTTING GUN (IF FITTED)
1. Steam available
machine, but pushing the
gun button no
available from nozzle.
1. The exhaust fan does not
work.
C H A P T E R 4
1. Causes:
a) Break of cable continuity.
b) Iron resistance burned.
c) Iron
faulty.
2. Thermostat contacts faulty.
3. Causes:
a) Iron temperature too low.
b) In case of machine with
boiler check that water to
the iron
suction
of the boiler itself.
4. Iron temperature too high.
to the 1. Causes:
a) Micro-switch
steam defective.
b) Break
continuity.
c) Solenoid valve coil burned.
EXHAUST FAN BREAKDOWNS
1. Causes:
a) Foreign objects block the fan.
b) The
pedal does not work.
c) The
burned out.
d) The motor is burned out.
thermostat contacts
is not a boiler
due to anomalies
contact
of the gun cable
micro-switch on the
motor condenser is
Page 4-7
E N G L I S H
1. Action:
a) Repair the electric cable
continuity.
b) Replace the
resistance.
c) Replace the
and the fuse.
2. Replace the thermostat.
3. Action:
a) Rotate the
thermostat
clockwise, increasing
iron temperature.
b) See
"Breakdowns to the boiler"
4. Rotate the iron thermostat
handwheel anticlockwise,
decreasing the
temperature.
1. Action:
a) Check the
contact and if necessary
replace it.
b) Check the continuity and
repair accordingly.
c) Replace burned coil.
1. Solutions:
a) Unblock the
removing the
bodies that are blocking
it.
b) Change the
on the pedal.
c) Change the
condenser.
d) Change the motor.
burned
thermostat
iron
handwheel
the
paragraph
iron
microswitch
fan by
foreign
micro-switch
motor