Operation - Power Stroke PSL1PS11 Manual Del Operador

CONNECTING HIGH PRESSURE HOSE/
PISTOL-GRIP SPRAYER
See Figure 3, page 17.
To connect the high pressure hose to the paint sprayer:
 Screw the collar of the high pressure hose onto the paint
connect outlet.
 Tighten securely with wrench provided.
To connect the pistol-grip sprayer to the high pressure
hose:
 Screw the collar on the high pressure hose onto the
pistol-grip sprayer by turning the hose collar clockwise.
 Using the wrenches provided, hold the nut on the pistol-
grip sprayer still while tightening securely the nut on the
high pressure hose.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result
in fluids entering your eyes resulting in possible serious
injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
ACCESSORIES
All accessories used with this product must be rated a mini-
mum of 3,200 psi. Ensure compatibility and fit before using
any accessory with this product.
WARNING:
Risk of fire or explosion − spray area must be well venti-
lated and away from spark of flames. Failure to heed this
warning could result in serious personal injury.
ASSEMBLY
INSTALLING INTAKE AND RETURN TUBES
See Figure 4, page 17.
 Insert the threaded end of the intake tube into the intake
tube connector on the back of the paint sprayer.
 Rotate the connector on the paint sprayer by hand until
the intake tube is attached securely.
 Slide the return tube over the fitting on the paint sprayer
until the tube is fully seated.
 Squeeze the tabs on the spring hose clamp and slide the
clamp over the tube and fitting. Release tabs to secure.

OPERATION

APPLICATIONS
You may use this product for the purposes listed below:
 Exterior painting and staining of decks, outdoor furniture,
fences, siding, and interior/exterior spray-painting of
walls, cabinets, and doors.
WARNING:
To reduce the risk of injection NEVER change spray tip
without setting the lock-off on the pistol-grip sprayer and
never point sprayer at any part of the body, persons, or
unit itself. In case of skin injection, seek medical attention
immediately. Failure to heed this warning could cause
serious personal injury.
LOCKING THE PISTOL-GRIP SPRAYER
See Figure 5, page 17.
Always lock the sprayer trigger when you have stopped
spraying to prevent the sprayer from being bumped or trig-
gered accidentally and causing injection.
 Pull the lock-off lever up to lock the sprayer trigger.
 Push the lock-off lever down to unlock the trigger.
RELEASE PRESSURE PROCEDURE
See Figures 5 - 6, page 17.
Always follow this procedure when shutting the paint sprayer
OFF for any reason. This procedure releases pressure in the
high pressure hose.
 Lock the sprayer trigger.
 Turn on/off switch OFF.
 Turn prime/spray lever to PRIME. This releases pump
pressure.
Page 9 — English