Lubrication; Thermal Protector; Troubleshooting - Hoover S5620 El Manual Del Propietario

luBriCation

The motor is equipped with bearings that contain sufficient lubrication for the life of the motor. The addition
of lubricant could cause damage. Therefore, do not add lubricant to motor bearings.
The agitator brushroll is equipped with two ball bearings that should be lubricated periodically by an
Authorized Hoover Warranty Service Dealer.

therMal ProteCtor

An internal thermal protector has been designed into your cleaner to protect it from overheating.
When the thermal protector activates, the cleaner will stop running. If this happens, proceed as follows:
1. Turn the cleaner OFF and disconnect it from the electrical outlet.
2. Check secondary and final filters for dirt accumulation.
3. Refer to "Clearing blockages" section.
4. When cleaner is unplugged and the motor cools for 30 minutes, the thermal protector automatically
resets and cleaning may continue.
If the thermal protector continues to activate after following the above steps, your cleaner may need
servicing (see "Service" section).
If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the
checklist below.
Any other servicing should be done by an authorized service representative.
To reduce risk of personal injury - unplug Power Canister before servicing.
ProBleM
low suction.
Cleaner won't
run.

5. trouBleshootinG

WARNING
!
PossiBle Cause
1. Filter dirty.
2. Obstruction in hose, piping or
cleaning tools.
1. Not firmly plugged in.
2. No voltage in wall plug.
3. Blown fuse/tripped breaker.
4. Low voltage circuit incorrectly
installed.
5. Defective wall valve.
6. Problem with low voltage
circuit.
!
PossiBle solution
1. Clean filter.
2. See "Clearing Blockages" - Pg. 8.
1. Plug in firmly.
2. Check fuse or breaker.
3. Replace fuse/reset breaker.
4. Short low voltage terminals at power unit, if
unit starts, there is a problem with the low
volt circuit.
5. Insert the hose into another inlet valve.
If unit turns on, the inlet valve may be
defective. Replace inlet valve.
6. If the unit starts, the problem is in the
wiring to the inlet valve, the 24 Volt
transformer or the relay. Contact your local
Hoover Sales and Service Center. See
Service Section.
9