Network Connection - Wired - Samsung 5 Serie Manual De Usuario

Network Connection - Wired

There are two main ways to connect your TV to your network using cable, depending on your network setup. They are
illustrated below:
The Modem Port on the Wall
The LAN Port on the Wall
✎
A network speed of lower than 10 Mbps is not supported.
Configuring the Network Connection - Wired
Most home networks use the Dynamic Host Configuration Protocol (DHCP) to configure network connections. Home networks
that support DHCP automatically provide the IP address, subnet mask, gateway, and DNS values your TV needs to access
the Internet so you don't have to enter them manually.
To configure your network connection for a network that uses DHCP, follow these steps:
1. Connect your TV to your network as shown in one of the
illustrations above.
2. Turn on your TV, press the
then select the Network → Network Settings.
3. Select Wired.
The network connection screen appears and verifies the
4.
network connection. When the connection has been verified,
the "Internet is connected successfully." message appears.
✎
If your TV cannot acquire network the connection values
automatically or if you want to set up the connection
manually, select IP Settings on the network connection
screen. Set IP Mode to Manual. You must enter the IP
Address, Subnet Mask, Gateway, and DNS Server
manually.
✎
For the detailed information, refer to "Network Settings" in the e-Manual.
(ADSL / VDSL / Cable TV)
Modem Cable
LAN Cable
MENU button on your remote, and
English - 13
External Modem
LAN Cable
IP Mode
IP Address
Subnet Mask
Gateway
DNS Mode
DNS Server
TV Rear Panel
TV Rear Panel
IP Settings
►
Manual
. . .
. . .
. . .
Manual
. . .
OK
U Move E Enter R Return