Supplied Accessories; Attaching The Stand; Symbols Used In This Manual; Trademark Information - Sylvania LC195SL8A El Manual Del Propietario

I
NTRODUCTION

Supplied Accessories

owner's manual
(1EMN22419A)
• If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free
customer support line found on the cover of this manual.
• Depending on your antenna system, you may need different types of combiners (mixers) or separators (splitters).
Contact your local electronics store for these items.

Attaching the Stand

You must attach the stand to the unit to display upright. Be sure the front and rear of the stand match the proper direction.
1
Turn the main unit over and place
it onto a table which has a soft
cloth draped over it. Make sure
not to damage the screen.
Note:
• When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly attached, it could cause the unit to fall,
resulting in injuries as well as damage to the unit.
• Make sure to use a table which can support the weight of this unit and is larger than this unit.
• Make sure the table is in a stable location.

Symbols Used in this Manual

The following is the description for the symbols used
in this manual. Description refers to:
: Digital TV operation
DTV
: Analog TV operation
TV
• If neither symbol appears under the function
heading, operation is applicable to both.

Trademark Information

• Manufactured under license from Dolby Laboratories.
"Dolby" and the double-D symbol are trademarks of
Dolby Laboratories.
• Product that have earned ENERGY STAR® are designed
to protect the environment through superior energy
efficiency.
4
EN
remote control
(NF604UD)
2
Insert the stand all the way to the
main unit slowly.
Make sure not to put the AC cord
between the stand and the unit.
batteries
(AA x 2)
3
Drive Phillips pan screws in the 2
threaded holes with a screwdriver
tightly.

Tilt Stand

You can adjust the stand to change the angle
of the TV (-3° to 8°).
-3°
Phillips pan screw for
attaching the stand x 2
(FPH34140)
8°