Safety Notices - EDELRID EN 354 Indicaciones De Uso

An anchor device according to / following EN 795 B may not be
used in a fall arrest system without energy absorbers according
to EN 355.
Prior to using a fall arrest system, please ensure that the
necessary free space in the work area (unobstructed height) of
7 m underneath the user is provided for.
caution! Connectors for anchoring aids according to EN 795
B must comply with EN 362.
All adjustable parts must be checked regularly during use.
general information on chooSing an anchor Point,
SafetY, Product
identification
anchor Point
In order to avoid high loads and swinging falls in the event of a
fall, anchor points for belay purposes must always be as vertical
as possible above the person to be belayed. The lanyard from the
anchor point to the person secured should always be kept as taut
as possible. Slack ropes must be avoided! The anchor point must
be designed in such a way that, when fixing the PPE, no effects
can occur which reduce the stability and it is not damaged during
use. Sharp edges, ridges and crushing can seriously impair the
stability. These should be covered, where necessary, using
suitable auxiliary equipment. The anchor point and the anchoring
must be able to withstand the expected loads in a worst-case
scenario.
Even when using shock absorbers (according to EN 355) the
anchor points should be designed for catching forces of at least
10 kN, also see EN 795.

SafetY noticeS

When combining this product with other components, the safety
aspects of the products may interfere with each other.
life, Storage, care
If this product is used in combination with other
components of a rescue/fall arrest system, users must
acquaint themselves with the enclosed recommendations, notes
and instructions for these components prior to use and comply
with them. This equipment should only be used in connection
with parts of personal protective equipment (PPE) bearing the
CE-symbol to protect individuals against falls from heights.
If original components are modified or removed from the
product, its safety aspects may be restricted. The equipment
should not be modified in any way or altered to allow attachment
of additional parts without the manufacturer's written
recommendation.
and The equipment must be checked for possible damage before and
after each use. It must be ensured that the equipment is
serviceable and fully functional. The equipment must be
discarded immediately if there is even the slightest doubt as to
its serviceability.
warning! The products must be kept away from damaging
environments. This includes contact with corrosive and
aggressive substances (e.g. acids, alkalis, soldering water, oils,
cleaning agents), as well as extreme temperatures and flying
sparks.
In addition, sharp edges, wetness and especially icing-up can
diminish the stability of textiles!
climate reQuirementS
The permanent use temperature of the product (in dry condition)
ranges from approx. -20°C to +55°C.
lifeSPan and rePlacement
The lifespan of the product mainly depends mainly on the way
and frequency in which it is used and external influences.
Products made from synthetic fibre (polyamide, polyester,