Description Of The Device; Functional Overview - Stylies Pegasus Instrucciones De Uso

DESCRIPTION OF THE DEVICE

The device consists of the following main components:
Drawing 1
1. Puriier
2. LED displays speed 1-5
Drawing 2
3. Adapter
4. Adapter plug socket
5. Puriier door
6. Fragrance tray
Drawing 3
7. On/Of Switch
8. Button for power setting
9. Button for timer
10. LED displays timer 2, 4 or 8 hours
11. Button for night mode
12. Pre-Filter
13. HPP™ Filter
14. Activated carbon ilter
FIRST USE / OPERATION
1. Place the Pegasus air puriier on a lat surface in the desired area. Plug the adaptor (3)
into a suitable electric socket.
2. Remove the activated carbon ilter (14) from the polyethylene bag before operating.
3. Then switch on the appliance by pressing the on/of switch (7).
4. You can adjust the speed and thus the puriication rate (volume per hour) by pressing
power setting button (8) (one blue lamp for level 1, two blue lamps for level 2, etc.).
5. You can use the timer to set the desired cleaning time. To do this, press on the timer
button (9). You can choose between the following periods: 2 hours, 4 hours or 8 hours. If
you do not wish to use the timer, you may run the air puriier in continuous operation (no
LED lamps illuminated).
6. If you ind the lamps too bright (in a bedroom for example), you may reduce the light inten-
sity by pressing the night mode key (11). The night mode can be switched of by pressing
the key once again.
7. You may use the Pegasus air puriier to distribute fragrances in the room. Please be as
economical as possible in the use of fragrances, because excessive quantities may lead to
malfunctions and damage to the appliance. To use fragrances, remove the fragrance tray
(6) from its mounting. Place no more than 1-2 drops of fragrance in the container and
replace it in its designated position. If you wish to change the fragrance, you can wash out
the fragrance container and leece under running water.

FUNCTIONAL OVERVIEW

Preliminary ilter
The preliminary ilter removes large dust particles and pollutants from the air, thereby protecting
the secondary ilter from severe soiling and optimising its functionality. The preliminary ilter can be
vacuum-cleaned when the need arises. Because the ilter material becomes worn in the course of
time, the ilter should be replaced at approximately 6-month intervals.
HPP™ Filter System
The HPP™ ilter is the heart of the air puriier. It ilters out viruses, bacteria, ine dust, pollen, dust
mite excretions and mould fungi from the room air. Its high eiciency is ensured by the use of ex-
tremely powerful magnetic ields.
9