Mode Of Control; Measurement Scale - Chauvin Arnoux STATOP 9601 Manual De Instrucciones

5.1. CONTROL MODE
The controller is supplied for a given control mode, as specified in the order.
This mode can be changed. To do this, make or cut the link at J11, using a soldering iron.
CONTROL MODE
On/Off
Proportional (P)

5.2. MEASUREMENT SCALE

The controller is supplied for a given type of sensor and measurement scale, specified in the
order. Only the measurement scale can be modified. To do this, solder the corresponding link,
without forgetting to cut the former link.
SCALE
0...100°C
0...300°C
0...400°C
0...600°C
0...1200°C
Unstick the dial on the front panel and replace it with the dial corresponding to its new
measurement extent (to order this dial, ask for details). No recalibration is necessary.
NOTE: the type of input (J couple, K couple or Pt 100Ω resistance) is not modifiable.
LINK TO BE MADE
J3
J5
J6
J8
J10
J11
Closed
Open
23