Attaching The Fan Blades - HAMPTON BAY Irondale 1969 Manual Del Propietário

Attaching the Fan Blades

1. A ttach the fan blades to the blade holders by
using three screws and fiber washers as shown
in Figure 15. Start a screw into the blade
holder, do not tighten. Repeat for the 2
remaining screws and washers.
2.Tighten each screw securely starting with
the center screw.
Repeat process for the other blades.
3. Remove the screws and rubber block from
the bottom motor before fasten the blade
a s s e m b l i e s t o t h e b o t t o m m o t o r
housing. (Figure 16)
4.Tighten the blade assemblies onto bottom
motor by using two screws from the loose
parts. Repeat process for the other blade
holders. (Figure 17)
Screws
Fiber
Washer
Blade
holder
Figure 15
Figure 16
Figure 17
Blade
Figure 18
Washer
Screw
Touching
ceiling
The following procedure should correct
most fan wobble. Check after each step.
1. Check that all blades and blade holder
screws are secure.
2. M ost fan wobble problems are caused
when blade levels are unequal. Check this
level by selecting a point on the ceiling
above the tip of one of the blades. Measure
this distance as shown in Figure 18. Rotate
the fan until the next blade is positioned for
measurement. Repeat for each blade. The
distance should be equal within 1/8".
(Figure18)
If all blade levels are not equal, you can
adjust the blade level with the following
procedure.
3. Use the enclosed Blade Balancing Kit if
the blade wobble is still noticeable. Please
refer to the introduction provide in the
blade balancing kit, which is individual
packed.
4. If the blade wobble is still noticeable,
i n t e r c h a n g i n g t w o a d j a c e n t ( s i d e b y
side)blades can redistribute the weight and
possibly result in smoother operation.
7