Descargar Imprimir esta página

Assembly And Operation - Oh!FX E-SHOT PRO Manual De Instrucciones

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY AND OPERATION

Placement: Prior you fi x the device, make sure that you have enough height or space around
for the confetti or streamers which will be projected, preventing that they may impact against
people or objects, causing damage. For your reference, check the below table of results
according to each consumable used
1. Place the ESHOT PRO device/s in the intended place, either on a fl at and stable surface
or hung on a truss structure using a clamp screwed into the nut anchor (8). Ensure the
machine with a safety cable.
2. Connect a Powercon input cable (10) to the power Input of the machine (4) and the other
end of the cable (schuko) to a Power control. Then, connect the Power control to a 220V
socket. If you want to shoot several E-SHOT PRO devices simultaneously from the same
power control, simply link the machines by connecting a Powercon cable (male-female),
connected on the Power out connector (5) of the 1st machine, to the Power Input (4) of
the next device, and so on. Thus, when pushing the power control button, all the linked
devices will be fi red at once.
3. You can use diff erent control systems to fi re the machine (eg: 1 CHANNEL FX PUSHER,
1 CHANNEL DMX SWITCH, etc.). Once connected your control system, make a shooting
test without plugging any electric cannon. If the setup is correct, the led indicator (7) will
light on, while you are doing the fi ring test.
4. Insert the electric confetti cannon (9) in the accommodation cylinder (1) and secure it
by tightening the safety fi xing knob (3). There exist safety cables (as accessories not
included), to further ensure the electric cannon so that it cannot get projected.
5. Adjust the desired inclination of the device and tighten the locking knob (2)
6. Connect the plug of the electric cannon (9) in the connector for electric cannons (6) of the
device.
7. Shooting: The device is now ready for use. Simply push on the switch power control to
make a shot.
GENERAL CAUTION FOR E-SHOT PRO
The function of the E-SHOT PRO is the release of confetti and streamers Any other use,
diff erent from the written excludes Oh!FX (CONFETTISHOTS SLU) of liability and warranty
Use only the consumables intended for that specifi c use, and duly certifi ed.
In case of malfunction, do not attempt to disassemble the machine and contact the
distributor or manufacturer. Any manipulation may exclude the warranty
Do not wet the machine. To clean it, use a damp cloth and dry it immediately.
Only one adult and qualifi ed person must manipulate the machine.
3
INSTRUCTION MANUAL

Publicidad

loading