Publicidad
ROYAL 10X PAPER SHREDDER
Setup:
1. The 10X shredder should be placed on a flat level surface. Depending on the type
of floor surface where the shredder is to be placed, casters have been included and
can be installed easily. It is recommended that casters only be used if the shredder
is being placed on a hard smooth surface.
2. To install the casters, carefully lay the shredder on its back. Place the long post of
each caster inside the hole located in each corner on the bottom of the shredder.
Push each caster into place until you hear or fell it snap and lock in place. Place
the shredder in an upright position. Make sure that the shredder stands evenly and
that all four casters fits squarely on the floor.
3. Make sure that the wastebasket is completely inserted in to the shredder cabinet and
that it fits flush with the shredder cabinet.
4. Plug the power cord into any standard 115-volt AC outlet.
5. Place the slide switch in the AUTO position. The Power Ready LED should light
up. You are now ready to start shredding.
Operating the shredder:
With the electrical cord plugged in, the slide switch in the AUTO position and the
shredder wastebasket properly in place, the Power Ready LED will light up. This
means that the shredder is now ready for operation. When the paper is inserted into
the feed opening, the shredding process will start automatically and stop when the
paper has completed its travel through the feed opening.
The Royal 10X slide switch is located on the top of the shredder. Also located on top
of the shredder is the Power Ready LED. Their purposes are:
1. When the slide switch is in the AUTO position, the shredding process will start
when paper is inserted into the feed opening and will continue until it has completely
passes through the feed opening.
2. The REV position on the slide switch is used to assist in the removal of a paper jam,
which reverses the shredding process prior to a completed forward cycle, thus
clearing the cutters. When switching from AUTO to REV, always stop in the OFF
position to prevent possible damage to the motor.
3. The OFF position is used to terminate the AC power to the shredder. It is
recommended to turn the shredder off when the shredder is not being used for a
prolonged period of time.
4. When the Power Ready LED is lit up it lets the user know that the wastebasket is
inserted correctly and that the shredder is turned on and ready for use. If the Power
Ready LED does not light up, make sure that the plug is plugged in, the basket is
inserted correctly and fully and the slide switch is in the AUTO position.
Shredder capacity:
The Royal 10X will shred up to ten (10) sheets of 20-lb. bond paper and will accept
paper widths up to 9". When shredding small material like envelopes or credit card
receipts, insert them in the middle of the feed opening.
Cautions:
1. Keep all loose articles of clothing, ties, jewelry, hair or other small items away from
the feed opening to prevent injury.
2. Keep the shredder turned off or unplugged when not in use for prolonged periods
of time.
1
10
Publicidad
