Numark DXM06 Manual De Inicio Rápido Para El Usuario página 4

FX Assign: Move the toggle to select the channel you would like to process.
FX ON: Activates and deactivates the effects
FX Select: The effects can be applied to MIC/AUX, CH1, CH2, or MASTER. When FX Assign is set to
MIC/AUX, you can select from the 6 FX written in small text along the bottom row (Vocoder,
FX Parameters: These controls vary by effect. WARNING Adjust slowly while learning these effects.
BEAT SYNC/TAP ASSIST: In order to align the effects with the beat, tap the beat sync to the rhythm 3-
4 times on the beat. If it has trouble syncing, try again. The beat sync often works best when
tapping to half the tempo. For example, try tapping on just the snare drums (typically the "2"
and "4" count). If the beat tap loses sync slightly, don't worry about tapping it in again, the
FX will likely still maintain sync. Otherwise, you can tap on beat once to re-sync.
When in beat sync, effects below denoted with an asterisk (*) will have rates or times which
are related to the tempo. Use the RATE/FREQUENCY knob to adjust the multiple of the tempo
(1x,2x,4x, etc.).
To disable beat sync and have continuous control over the rate/time of an effect, simply press
and hold the beat sync button until it remains lit. Now the RATE/FREQUENCY knob will allow
you to precisely tune a rate or frequency. To re-enable beat sync, tap out the beat again.
DXM06 Effects section
These effects are dangerously fun to play with. When you're playing alone, go
nuts. When you play live, remember that your crowd sometimes just wants to
hear the song. Be subtle!
Tape echo, Echo, Reverb 1, Reverb 2, LMT+DSTR).
When set to CH1, CH2 or MASTER, you can select
from the 6 FX written in the in large text along the
top row (2XCopy, Tape Echo, Echo, Flanger, Phaser,
Filter).